Pedal, Accelerator: Removal: Removal

WARNING: This page is about a different car, the 2013 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Do not attempt to separate or remove the Accelerator Pedal Position Sensor (APPS) from the accelerator pedal assembly. The APPS and the accelerator pedal is replaced as an assembly. If the sensor is removed from the pedal, the electronic calibration may be destroyed.

Fig 1: Accelerator Pedal Position Sensor (APPS)

Courtesy of CHRYSLER GROUP, LLC

Disconnect the 6-way electrical connector at the APPS (1).
Remove the upper accelerator pedal mounting bolt (2).
Remove the lower accelerator pedal mounting bolt (3).
Remove the accelerator pedal assembly from the vehicle.