LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 26 (Starting (Service Information)) >> Starter >> Installation >> Diesel >> 6.7L Diesel

6.7L Diesel

WARNING: This page is about a different car, the 2011 RAM Pickup and 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect solenoid wire to starter motor. Tighten nut to 4.4 ft. lbs. (6 N.m).
  2. Position battery cable to starter stud. Install and tighten battery cable nut to 10.3 ft. lbs. (14 N.m). Do not allow starter motor to hang from wire harness.
  3. Position starter motor to transmission.
  4. Install and tighten 3 starter mounting bolts to 32 ft. lbs. (43 N.m).
  5. Lower vehicle.
  6. Connect both negative battery cables to both batteries.
scientia non olet · About LEMON Manuals