Gasoline Engine
WARNING: This page is about a different car, the 2011 RAM Pickup and 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
- Install a new rubber grommet seal into the washer fluid level switch mounting hole of the washer reservoir (3). Always use a new rubber grommet seal on the reservoir.
- Insert the nipple formation of the switch (2) through the rubber grommet seal in the reservoir.
- Using hand pressure, press firmly and evenly on the switch mounting flange until the barbed nipple is fully seated in the rubber grommet seal in the reservoir. The flat edge of the switch mounting flange should be pointed upward.
- Reconnect the Front End Module (FEM) wire harness connector (1) to the switch connector receptacle.
- Reinstall the washer reservoir onto the FEM carrier (also known as the radiator closure). Refer to RESERVOIR, Windshield Washer , Installation .