LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 24 (Emissions Control) >> Exhaust Gas Recirculation, 6.7L Diesel >> VALVE, Exhaust Gas Recirculation (EGR), 6.7L >> Removal >> Pick Up Models

Pick Up Models

WARNING: This page is about a different car, the 2011 RAM Pickup and 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing/Installing EGR Crossover Tube Cover
GC0108069Courtesy of CHRYSLER LLC
  1. Disconnect both negative battery cables.
  2. Remove bolts (1) and the EGR crossover tube cover (2).
    Fig 2: Removing/Installing EGR Crossover Tube
    GC0137182Courtesy of CHRYSLER LLC
  3. Loosen clamp (1). Remove clamp (3) at end of EGR crossover tube (2).
  4. Remove bolt (5) at center bottom of EGR crossover tube.
    Fig 3: Removing/Installing EGR Valve Assembly - 6.7L
    GC0108459Courtesy of CHRYSLER LLC
  5. Disconnect the EGR valve harness connector.
  6. Remove the four EGR valve assembly mounting bolts (1).
  7. Remove EGR valve assembly (2) from intake connector (3) by prying up.
    Fig 4: Removing/Installing EGR Valve Gaskets
    GC0110296Courtesy of CHRYSLER LLC
  8. Remove crossover tube gasket (1) and clean EGR valve. Also clean end of EGR tube of any old gasket material.
  9. Remove two gaskets on bottom EGR valve (4). Clean bottom of EGR valve and top of its intake connection point of any old gasket material.
scientia non olet · About LEMON Manuals