Cab/Chassis Models

WARNING: This page is about a different car, the 2011 RAM Pickup and 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing EGR Valve Gaskets

Courtesy of CHRYSLER LLC

Install new gasket (1) to end of EGR tube.

Fig 2: Removing/Installing EGR Valve Assembly - 6.7L
Courtesy of CHRYSLER LLC
Position EGR valve assembly (2) and install the four EGR valve mounting bolts (1) finger tight.

Fig 3: Removing/Installing EGR Crossover Tube
Courtesy of CHRYSLER LLC
Install and lightly tighten two clamps (1) and (3) at ends of EGR crossover tube.
Install "P" clamp bolt (5) finger tight only.
Tighten clamp (1) first to 10 N.m. (89 in. lbs.), then tighten clamp (3) to 10 N.m. (89 in. lbs.).
Tighten "P" clamp bolt (5) to 10 N.m (89 in. lbs.).

Fig 4: Removing/Installing EGR Valve Assembly - 6.7L
Courtesy of CHRYSLER LLC

Tighten the four EGR valve mounting bolts in a criss-cross fashion to 24 N.m (18 ft. lbs.).

Fig 5: Removing/Installing EGR Temperature Sensor

Courtesy of CHRYSLER LLC

1	EGR Temperature Sensor
2	Sensor Harness Connector
3	Crossover Tube
4	EGR Actuator
5	EGR Actuator Harness Connector
6	EGR Tube

Connect the EGR Actuator harness connector (5).

Fig 6: Removing/Installing EGR Crossover Tube Cover
Courtesy of CHRYSLER LLC
Install EGR crossover tube cover (2). Tighten bolts (1) to 10 N.m (89 in. lbs.).
Connect both negative battery cables.