LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 24 (Emissions Control) >> Exhaust Gas Recirculation, 6.7L Diesel >> TUBE, Exhaust Gas Recirculation (EGR), Crossover >> Removal >> Cab/Chassis Models

Cab/Chassis Models

WARNING: This page is about a different car, the 2011 RAM Pickup and 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing/Installing EGR Crossover Tube Cover
GC0108069Courtesy of CHRYSLER LLC
  1. Disconnect both negative battery cables.
  2. Remove four bolts (1) and EGR crossover tube cover (2).
    Fig 2: Removing/Installing EGR Crossover Tube
    GC0110290Courtesy of CHRYSLER LLC
  3. Disconnect EGR Temperature Sensor harness connector (4).
  4. Loosen and remove two clamps (1) and (3) at ends of EGR Crossover Tube.
  5. Remove "P" clamp mounting bolt (5) at center of EGR Crossover Tube.
  6. Remove EGR Crossover Tube (2).
  7. Remove and discard gaskets (doughnuts) at each end of tube.
scientia non olet · About LEMON Manuals