LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 24 (Emissions Control) >> Exhaust Gas Recirculation, 6.7L Diesel >> TUBE, Exhaust Gas Recirculation (EGR), Crossover >> Installation >> Pick Up Models

Pick Up Models

WARNING: This page is about a different car, the 2011 RAM Pickup and 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing/Installing EGR Crossover Tube
GC0137182Courtesy of CHRYSLER LLC
  1. Clean each end of EGR crossover tube and its connection points of any old gasket material.
  2. Install new gaskets to each end of the EGR crossover tube (2).
  3. Position EGR crossover tube (2) to engine.
  4. Install bolt (5) finger tight at center bottom of EGR crossover tube.
  5. First, tighten EGR tube clamp (1) to 10 N.m (89 in. lbs.), then tighten clamp (3) to 10 N.m (89 in. lbs.).
  6. Tighten bolt (5) to 10 N.m (89 in. lbs.).
  7. Connect the EGR temperature sensor harness connector (4).
    Fig 2: Removing/Installing EGR Crossover Tube Cover
    GC0108069Courtesy of CHRYSLER LLC
  8. Install the EGR crossover tube cover (2). Tighten bolts (1) to 10 N.m (89 in. lbs.).
  9. Connect both negative battery cables.
scientia non olet · About LEMON Manuals