Bank 1 Sensor 2

WARNING: This page is about a different car, the 2011 RAM Pickup and 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing NOx Sensor Module

Courtesy of CHRYSLER LLC

Disconnect both negative battery cables.
Disconnect the NOx sensor module harness connector (3).
Remove nuts (1) and the NOx module (2).

Fig 2: Removing/Installing NOx Sensor
Courtesy of CHRYSLER LLC
Disconnect the wire harness retainers.
Remove the NOx sensor (1) from the Selective Catalytic Reduction (SCR) catalyst (2).