LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 233 (DTCS P0219 To P1D93 - 8HP45 Automatic Transmission - 1500) >> Diagnosis And Testing >> P0980-Shift Solenoid C Control Circuit High >> Set Condition

Set Condition

WARNING: This page is about a different car, the 2013 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.

A failure is detected if one of the following conditions occurs. A short to battery failure is detected if the voltage output signal during PWM duty phase is greater than a calibrated threshold. An open circuit failure is detected if the voltage of the output signal during PWM duty cycle is in an invalid range. A short to ground failure is detected if the voltage of the output signal during PWM duty cycle is less than a calibrated threshold. A short to ground or open circuit failure is detected if the commanded duty cycle for the solenoid is 100% and the TCM indicates the output stage is switched off.

scientia non olet · About LEMON Manuals