Section 23 (Charging (Service Information)): Generator: Removal: Diesel
WARNING: This page is about a different car, the 2011 RAM Pickup and 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - GENERATOR |
| 2 - MOUNTING BOLTS |
WARNING:
Disconnect both negative cables from both batteries before removing battery output wire (B+ wire) from generator. Failure to do so can result in injury or damage to electrical system.
- Disconnect both negative battery cables at both batteries.
- Remove generator drive belt. Refer to REMOVAL for procedure.
- Remove upper mounting bracket bolt (2). Refer to Fig 1.
- Remove lower mounting bracket bolt and nut (2). Refer to Fig 1.
- Remove generator from engine.
1 - B+ CONNECTOR 2 - GENERATOR 3 - FIELD WIRE CONNECTOR - Unsnap plastic insulator cap (1) from B+ output terminal.
- Remove B+ terminal mounting nut at rear of generator. Disconnect terminal from generator.
- Disconnect field wire connector (3) at rear of generator by pushing on connector tab.