Section 23 (Charging (Service Information)): Generator: Installation: Diesel
WARNING: This page is about a different car, the 2011 RAM Pickup and 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
- Position generator to upper and lower mounting brackets and install upper bolt and lower bolt / nut.
- Tighten all bolts/nut to 30 ft. lbs. (41 N.m).
- Snap field wire connector into rear of generator.
- Install B+ terminal eyelet to generator output stud. Tighten mounting nut. Refer to TORQUE SPECIFICATIONS - GENERATOR/CHARGING SYSTEM .CAUTION:
Never force a belt over a pulley rim using a screwdriver. The synthetic fiber of the belt can be damaged.
CAUTION:When installing a serpentine accessory drive belt, the belt must be routed correctly. The water pump may be rotating in the wrong direction if the belt is installed incorrectly, causing the engine to overheat. Refer to belt routing label in engine compartment, or refer to REMOVAL in Cooling System.
- Install generator drive belt. Refer to INSTALLATION for procedure.
- Install both negative battery cables to both batteries.