Section 221 (6.7L - Diesel AFTERTREATMENT Validation, Mil Light On Pretest Procedure, Pre-Diagnostic Troubleshooting Procedure, Pcm/ECM/TCM Programming, Powertrain Verification Test & Intermittent Condition - 3500 Cab & Chassis, 4500 & 5500)
WARNING: This page is about a different car, the 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
- Standard Procedure
- Diesel AFTERTREATMENT Validation- 6.7L
- Mil Light On Pretest Procedure
- Pre-Diagnostic Troubleshooting Procedure - 6.7L
- Pcm/ECM / TCM Programming
- Pcm/ECM / TCM Flash PROGRAMING
- Table Of Contents
- Section 1 - Pcm/ECM / TCM Flash Procedure
- Repair Procedure - Using STARSCAN® Or STARMOBILE® Desktop Client
- Repair Procedure - WITECH™ Diagnostic Application
- Section 2 - Additional Pcm/ECM / TCM Replacement Procedures
- Notes
- If a 2.0L Controller was replaced, navigate to "Misc. Functions" and perform all applicable routines:
- If a PT Cruiser, 2.2L Controller was replaced, navigate to "Misc. Functions" and perform all applicable routines:
- If a 3.0L Controller was replaced, navigate to "Misc. Functions" and perform all applicable routines:
- If a 2.8L Controller was replaced, navigate to "Misc. Functions" and perform all applicable routines:
- If a PM/MK, 2.2L Controller was replaced, navigate to "Misc. Functions" and perform all applicable routines:
- If a 5.9L Controller was replaced, navigate to "Misc. Functions" and perform all applicable routines:
- If a 6.7L Controller was replaced, navigate to "Misc. Functions" and perform all applicable routines:
- TCM Replacement:
- If an EGS TCM was replaced, perform the following additional steps and/or routines:
- Step-By-Step Instructions
- Section 3 - Authorized Modification Label
- Required Tools / Equipment:
- Tech Tips And Information:
- Parts Required
- Powertrain Verification Test - 6.7L
- Intermittent Condition - 6.7L