Torque Specifications
WARNING: This page is about a different car, the 2011 RAM Pickup and 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
6.7L DIESEL ENGINE
| DESCRIPTION | N.m | In. Lbs. | Ft. Lbs. |
|---|---|---|---|
| Connecting Rod - Bolts | |||
| Step 1 | 30 | - | 22 |
| Step 2 | 60 | - | 44 |
| Step 3 | Rotate 60 degrees | ||
|
CAUTION:
The 6.7L engine has different torque procedures for new and previously installed main bearing capscrews. Failure to use the correct torque procedure can result in engine damage. |
|||
| Crankshaft Main Cap - Bolts (Previously Used) | |||
| Step 1 | 60 | - | 44 |
| Step 2 | 80 | - | 59 |
| Step 3 | Rotate 90° | ||
| Crankshaft Main Cap - Bolts (New Main Bearing Capscrews) | N.m | In. Lbs. | Ft. Lbs. |
| Step 1 | 120 | - | 89 |
| Step 2 | Loosen completely | - | Loosen completely |
| Step 3 | 60 | - | 44 |
| Step 4 | 85 | - | 63 |
| Step 5 | Rotate 120° | ||
| Cylinder Head - Bolts | |||
| Step 1 | 70 | - | 52 |
| Step 2 | Back off 360 degrees | ||
| Step 3 | 105 | - | 77 |
| Step 4 Verify | 105 | - | 77 |
| Step 5 | Rotate All Bolts 1/4 Turn | ||
| Cylinder Head Cover Bolts | 24 | - | 18 |
| Accessory Drive Belt Tensioner Bolt | 43 | - | 32 |
| Air Inlet to Intake Manifold Bolts | 24 | - | 18 |
| Air Cleaner Body Bolt | 8 | 70 | - |
| Air Cleaner Intake Air Tube Clamp | 4 | - | 35 |
| Bell Housing Access Cover Bolts | 10 | 89 | - |
| Block Stiffener Bolts | 43 | - | 32 |
| Breather Cover Bolts | 10 | 89 | - |
| Charge Air Cooler Bolt | 2 | 18 | - |
| Charge Air Tube Clamps | 11 | 97 | - |
| Coolant Outlet Tube Bracket Bolt | 10 | 89 | - |
| Coolant Outlet Tube Bracket Nut | 24 | - | 18 |
| Crankshaft Damper Bolts | 40 + 60° | - | 30 + 60° |
| Delta-P line Bracket Bolt | 10 | 89 | - |
| Delta-P line Bracket Nut | 24 | - | 18 |
| Delta-P Flare Nut | 10 | 89 | - |
| Dual Mass Flywheel Bolts | 54 | - | 40 |
| Engine Cover Bolts | 10 | 89 | - |
| Engine Mount Bolt | 95 | - | 70 |
| Engine Mount Through Bolt Nut | 129 | - | 95 |
| Engine Wire Harness P-clip Bolts | 24 | - | 18 |
| Exhaust Manifold Bolts | 43 | - | 37 |
| Exhaust Manifold Heat Shield Nuts | 24 | - | 18 |
| Fan Support Hub | 32 | - | 24 |
| Flexplate to Engine | 137 | - | 100 |
| Flywheel to Engine | 137 | - | 100 |
| Flywheel/Crankshaft Adapter | 137 | - | 100 |
| Flywheel Housing Bolts | 77 | - | 57 |
| Forward Coolant Tube Bracket Bolts | 10 | 89 | - |
| Forward Coolant Tube Bolts | 10 | 89 | - |
| Front Cover | 24 | - | 18 |
| Fuel Delivery Lines - Banjo | 24 | - | 18 |
| Fuel Drain Line - Banjo | 24 | - | 18 |
| Fuel Injector Harness Nuts | 1.25 | 11 | - |
| Fuel Injector Hold-down | 5 | 44 | - |
| Step 2 | 10 | 89 | - |
| Fuel Injector Solenoid Nuts | 1.25 | 11 | - |
| Fuel Tube, No. 6 Bracket Shield Bolts | 43 | - | 32 |
| Fuel Tube - Rail to Cylinder Head | 40 | - | 30 |
| Fuel Tube - Pump to Fuel Rail | 37 | - | 27 |
| Fuel Rail Hold-down Bolt | 24 | - | 18 |
| Gear Housing Cover | 24 | - | 18 |
| HPC Nut | 50 | - | 37 |
| Intake Manifold Bolts | 24 | - | 18 |
| Intake Manifold Grid Heater Wire Harness Bolts | 10 | 89 | - |
| Oil Cooler Bolts | 24 | - | 18 |
| Oil Dip Stick Tube Bolt | 24 | - | 18 |
| Oil Dip Stick Tube Nut | 9 | 80 | - |
| Oil Pan - Bolts | 28 | - | 21 |
| Oil Pan - Drain Plug | 50 | - | 37 |
| Oil Pressure Regulator - Plug | 80 | - | 59 |
| Oil Pressure Switch to Block Fitting | 18 | - | 13 |
| Oil Pressure Switch to Block Fitting to Block | 30 | - | 22 |
| Oil Pump - Bolts | Refer to PUMP, Engine Oil, Installation, 6.7L . | ||
| Oil Suction Tube (Flange) - Bolts | 24 | - | 18 |
| Oil Suction Tube (Brace) - Bolt | 43 | - | 32 |
| Oxygen Sensor | 41 | - | 30 |
| P-Clip Bolt | 24 | - | 18 |
| Rack and Pinion Steering Gear to Frame Bolts (4X2) | 251 | - | 185 |
| Rocker Arm Housing Bolts | 24 | - | 18 |
| Rocker Arm/Pedestal - Bolts | 36 | - | 27 |
| Rocker Housing Bolts | 24 | - | 18 |
| Starter Motor Bolts | 40 | - | 30 |
| Torque Converter Bolts | 88 | - | 65 |
| Transmission to Engine Bolts (automatic) | 41 | - | 30 |
| Transmission to Engine Bolts (manual) | 45 | - | 33 |
| Transmission Mount to Crossmember Nuts | 47 | - | 35 |
| G 56 Transmission Mount Bolts | 50 | - | 37 |
| 68RFE Transmission Mount Bolts | 50 | - | 37 |
| AS68RC Transmission Mount Nuts | 47 | - | 35 |
| AS68RC Transmission Mount Support Bracket Bolts | 54 | - | 40 |
| AS68RC Transmission Side Support Bracket Bolt | 55 | - | 41 |
| AS68RC Transmission Upper Bracket Nut | 30 | - | 22 |
| Turbocharger Actuator Bolt | 11 | 97 | - |
| Turbocharger Air Inlet Tube Clamp | 11 | 97 | - |
| Turbocharger Cleaning Port Plug | 10 | 89 | - |
| Turbocharger Coolant Return Line Banjo Bolt | 24 | - | 18 |
| Turbocharger Coolant Supply Line Banjo Bolt | 24 | - | 18 |
| Turbocharger Nuts | 43 | - | 32 |
| Turbocharger Oil Drain Tube Bolt | 36 | - | 27 |
| Turbocharger Oil Supply Line Nut | 36 | - | 27 |
| Turbocharger Speed Sensor Bolt | 10 | 89 | - |
| Turbocharger V-Band Clamp Nut | 10 | 89 | - |
| Valve Lash Adjusting Nut | 24 | - | 18 |