As68RC Automatic

WARNING: This page is about a different car, the 2011 RAM Pickup and 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

If replacing a engine mount/bracket, be certain to inspect all other engine mounts/brackets in the system. Failure to follow this caution may result in damage to the vehicle.

Fig 1: Identifying Transmission Support Bracket & Bolts - AS68RC A/T

Courtesy of CHRYSLER LLC

Position the transmission mount support bracket (2). Install bolts (1) finger tight.

Fig 2: Identifying Transmission Mount Support Bracket Bolts - AS68RC A/T
Courtesy of CHRYSLER LLC
With the transmission raised, install the transmission mount support bracket to transmission bolts (1) and tighten to 54 N.m (40 ft. lbs.).

Fig 3: Identifying Transmission Support Bracket & Bolts - AS68RC A/T
Courtesy of CHRYSLER LLC
Tighten the side support bracket bolts (1) to 55 N.m (41 ft. lbs.).

Fig 4: Identifying Rear Transmission Mount & Nuts - AS68RC A/T
Courtesy of CHRYSLER LLC
Install the rear transmission mount (2). Tighten nuts (1) to 47 N.m (35 ft. lbs.).
Using the transmission jack, lower the transmission onto the crossmember.

Fig 5: Identifying Rear Transmission Mount To Crossmember Nuts - AS68RC A/T
Courtesy of CHRYSLER LLC
Install the transmission mount to crossmember nuts (1) Tighten nuts (1) to 47 N.m (35 ft. lbs.).
Remove the transmission jack.
Lower the vehicle on a hoist.