Possible Causes
WARNING: This page is about a different car, the 2012 RAM Pickup. However, it is still accessible from the selected car via links, so may be relevant.
| Possible Causes |
|---|
| (K41) O2 SENSOR 1/1 SIGNAL CIRCUIT SHORTED TO VOLTAGE |
| (K103) O2 SENSOR 1/1 PUMP CELL CURRENT TRIM CIRCUIT SHORTED TO VOLTAGE |
| (K902) O2 SENSOR 1/1 RETURN CIRCUIT SHORTED TO VOLTAGE |
| (K89) O2 SENSOR 1/1 POSITIVE CURRENT CONTROL CIRCUIT SHORTED TO VOLTAGE |
| O2 SENSOR 1/1 |
| SMART O2 SENSOR MODULE |
Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. Refer to PRE-DIAGNOSTIC TROUBLESHOOTING PROCEDURE - 6.7L .
NOTE:
Before replacing any O2 Sensor or O2 Sensor Module, check aftertreatment wiring harness for spread terminals. For wiring harness checking procedure, DO NOT back probe, use Electric Test Tool Kit (special tool #8197A, Electric Terminal Tool Kit) ((special tool #6801, Terminal Probe) Tool).