LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (5.7L Engine (Service Information)) >> Diagnosis And Testing >> Performance

Diagnosis And Testing: Performance

WARNING: This page is about a different car, the 2011 RAM Pickup and 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
CONDITION  POSSIBLE CAUSE  CORRECTION 
ENGINE WILL NOT START 1. Weak battery. 1. Charge or replace as necessary.
2. Corroded or loose battery connections. 2. Clean and tighten battery connections. Apply a coat of light mineral grease to the terminals.
3. Faulty starter. 3. Refer to Diagnosis and Testing .
4. Incorrect spark plug gap. 4. Refer to Specifications .
5. Dirt or water in fuel system. 5. Clean system and replace fuel filter.
6. Faulty fuel pump, relay or wiring. 6. Refer to Diagnosis and Testing .
ENGINE STALLS OR ROUGH IDLE 1. Idle speed set to low. 1. Refer to Diagnosis and Testing .
2. Vacuum leak. 2. Inspect intake manifold and vacuum hoses, repair or replace as necessary.
-
ENGINE LOSS OF POWER 1. Dirty or incorrectly gapped spark plugs. 1. Replace spark plugs.
2. Dirt or water in fuel system. 2. Clean system and replace fuel filter.
3. Blown cylinder head gasket. 3. Replace cylinder head gasket.
4. Low compression. 4. Refer to CYLINDER COMPRESSION PRESSURE LEAKAGE .
5. Burned, warped or pitted valves. 5. Replace as necessary.
6. Plugged or restricted exhaust system. 6. Inspect and replace as necessary.