Standard Stabilizer Bar
WARNING: This page is about a different car, the 2011 RAM Pickup and 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - RETAINER |
| 2 - GROMMET |
| 3 - STABILIZER BAR |
| 4 - AXLE BRACKET |
| 5 - STABILIZER LINK |
- Position the stabilizer bar on the frame rail and install the clamps and bolts. Ensure the bar is centered with equal spacing on both sides.
- Tighten the clamp bolts to specifications. Refer to SPECIFICATIONS .
- Install links (5), retainers (1), grommets (2) and nuts to the stabilizer bar (3). Hold the link shaft with a wrench and tighten the nuts to specifications. Refer to SPECIFICATIONS .
- Remove the supports and lower the vehicle.