Standard Link

WARNING: This page is about a different car, the 2011 RAM Pickup and 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Retainer, Grommet, Stabilizer Bar, Axle Bracket & Stabilizer Link

Courtesy of CHRYSLER LLC

1 - RETAINER

2 - GROMMET

3 - STABILIZER BAR

4 - AXLE BRACKET

5 - STABILIZER LINK

Install links (5) to the axle bracket (4) and tighten nut to specifications. Refer to SPECIFICATIONS .
Install links (5), retainers (1), grommets (2) and nuts to the stabilizer bar. Hold the link shaft with a wrench and tighten the nuts to specifications. Refer to SPECIFICATIONS .
Remove the supports and lower the vehicle.