Standard Procedure - Outer Tie Rod End Lubrication

WARNING: This page is about a different car, the 2011 RAM Pickup and 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

View in illustration is typical.

Fig 1: Locating Grease & Tie Rod End Boot

Courtesy of CHRYSLER LLC

NOTE:

If a new tie rod end is to be installed, make sure the boot (2) is properly lubricated.

Any time the outer tie rod end is disconnected from the knuckle, before assembly, clean all old grease and debris from the boot with a clean cloth and apply outer tie rod grease P/N 68088623AA (1) to the boot (2) as shown in illustration.