LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Front Suspension & Wheel Alignment) >> Front, Independent Front Suspension >> SHOCK ABSORBER, Suspension >> Installation >> 4X2

SHOCK ABSORBER, Suspension: Installation: 4X2

WARNING: This page is about a different car, the 2011 RAM Pickup and 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Shock Wrench And Grommet
GC0083205Courtesy of CHRYSLER LLC
NOTE:

Upper shock nut must be replaced or use Mopar Lock 'N Seal or Loctite R 242 on existing nut.

  1. Install the lower retainer and grommet on the shock absorber stud. Insert the shock absorber through the frame bracket hole.
  2. Install the lower bolts and tighten the bolts to specifications. Refer to SPECIFICATIONS .
  3. Install the upper grommet, retainer (2) and new nut or use Mopar Lock 'N Seal or Loctite R 242 on existing nut, on the shock absorber stud. Using Strut Nut Wrench (special tool #9362, Wrench, Strut Nut) (1), tighten nut to specifications. Refer to SPECIFICATIONS .
  4. Remove the support from the lower control arm outboard end.
  5. Remove the support and lower the vehicle.
scientia non olet · About LEMON Manuals