Diagnostic Test
WARNING: This page is about a different car, the 2012 RAM Pickup and 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
- INSPECT DRIVER SEAT SWITCH FOR DAMAGE
- Turn the ignition off.
- Inspect the Driver Seat Switch for damage.
Is the switch damaged?
Yes
- Replace the Driver Seat Switch in accordance with the Service Information.
- Perform POWER SEAT SYSTEM VERIFICATION TEST. Refer to POWER SEAT SYSTEM VERIFICATION TEST .
No
- Go To 2.
- INSPECT FOR OBJECT OR SUBSTANCE CAUSING DRIVER SEAT SWITCH TO STAY OR STICK IN A PUSHED POSITION
- Inspect the Driver Seat Switch for anything that would cause it to stay or stick in a pushed position.
Is anything present that would cause the switch to stay or stick in a pushed position?
Yes
- Repair as necessary.
- Perform POWER SEAT SYSTEM VERIFICATION TEST. Refer to POWER SEAT SYSTEM VERIFICATION TEST .
No
- Go To 3.
- Inspect the Driver Seat Switch for anything that would cause it to stay or stick in a pushed position.
- TEST FOR INTERMITTENT CONDITION
- Turn the ignition on.
- Using a scan tool, record and erase Diagnostic Trouble Codes (DTC's).
- Press the Driver Seat Switch in all directions several times then wait one minute.
- Using a scan tool, read DTC's.
Does the scan tool display DTC B1D62-POWER SEAT SWITCH STUCK?
Yes
- Replace the Driver Seat Switch in accordance with the Service Information.
- Perform POWER SEAT SYSTEM VERIFICATION TEST. Refer to POWER SEAT SYSTEM VERIFICATION TEST .
No
- The conditions that caused this code to set are not present at this time. Verify seat harness is routed correctly. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors. Look for chafed, pierced, pinched, or partially broken wires and broken, bent, pushed out, spread, corroded, or contaminated terminals.
- Perform POWER SEAT SYSTEM VERIFICATION TEST. Refer to POWER SEAT SYSTEM VERIFICATION TEST .