Engine Diagnosis - Performance

WARNING: This page is about a different car, the 2011 RAM Pickup. However, it is still accessible from the selected car via links, so may be relevant.

CONDITION	POSSIBLE CAUSE	CORRECTION
ENGINE WILL NOT START	1. Weak battery	1. Charge or replace as necessary.
	2. Corroded or loose battery connections.	2. Clean and tighten battery connections. Apply a coat of light mineral grease to the terminals.
	3. Faulty starter.	3. Refer to Diagnosis and Testing .
	4. Faulty coil or control unit.	4. Refer to COIL, Ignition , Removal .
	5. Incorrect spark plug gap.	5. Correct as necessary.
	6. Incorrect right bank cam timing.	6. Refer to STANDARD PROCEDURE .
	7. Dirt or water in fuel system.	7. Clean system and replace fuel filter.
	8. Faulty fuel pump, relay or wiring.	8. Repair or replace as necessary.
	9. Faulty cam or crank sensor	9. Refer to IGNITION SYSTEM - SERVICE INFORMATION article.
ENGINE STALLS OR ROUGH IDLE	1. Vacuum leak.	1. Inspect intake manifold and vacuum hoses, repair or replace as necessary.
	2. Faulty crank position sensor	2. Replace crank position sensor.
	3. Faulty coil.	3. Refer to COIL, Ignition , Removal .
	4. Incorrect cam timing.	4. Refer to STANDARD PROCEDURE .
ENGINE LOSS OF POWER	1. Dirty or incorrectly gapped spark plugs.	1. Correct as necessary.
	2. Dirt or water in fuel system.	2. Clean system and replace fuel filter.
	3. Faulty fuel pump.	3. Refer to FUEL DELIVERY, GAS or FUEL DELIVERY, 6.7L DIESEL .
	4. Blown cylinder head gasket.	4. Replace cylinder head gasket.
	5. Low compression.	5. Repair as necessary. Refer to CYLINDER COMPRESSION PRESSURE LEAKAGE .
	6. Burned, warped or pitted valves.	6. Replace as necessary.
	7. Plugged or restricted exhaust system.	7. Inspect and replace as necessary.
	8. Faulty coil.	8. Refer to COIL, Ignition , Removal .
	9. Incorrect cam timing.	9. Refer to STANDARD PROCEDURE .
ENGINE MISSES ON ACCELERATION	1. Spark plugs dirty or incorrectly gapped.	1. Correct as necessary.
	2. Dirt in fuel system.	2. Clean fuel system.
	3. Burned, warped or pitted valves.	3. Replace as necessary.
	4. Faulty coil.	4. Refer to COIL, Ignition , Removal .
ENGINE MISSES AT HIGH SPEED	1. Spark plugs dirty or incorrectly gapped.	1. Correct as necessary.
	2. Faulty coil.	2. Refer to COIL, Ignition , Removal .
	3. Dirt or water in fuel system.	3. Clean system and replace fuel filter.