LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 188 ((Drivetrain Control Module (DTCM) - Electrical Diagnostics - 1500, 2500 & 3500)) >> DTC Troubleshooting >> U0212-Lost Communication With SCM (SAS) >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2012 RAM Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. VERIFY DTC IS ACTIVE 
    1. Ignition on, engine not running.
    2. With the scan tool, record and erase DTCs.
    3. Cycle the ignition switch.
    4. With the scan tool, read DTCs.

      Is the DTC Active at this time?

      Yes 

      • Refer to DIAGNOSIS AND TESTING and perform the appropriate diagnostic procedure for the Steering Angle Sensor (SAS).

      No 

scientia non olet · About LEMON Manuals