Diagnostic Test

WARNING: This page is about a different car, the 2012 RAM Pickup. However, it is still accessible from the selected car via links, so may be relevant.

CHECK FOR DTC U0401-IMPLAUSIBLE DATA RECEIVED FROM TCM
NOTE:
This DTC must be active for the results of this test to be valid.
1. Turn the ignition on.
2. With the scan tool, record and erase DTCs.
3. Cycle the ignition switch from off to on.
4. With the scan tool, read DTCs.
  Does the scan tool display: U0401-IMPLAUSIBLE DATA RECEIVED FROM TCM?
  
  Yes
  - Go To 2.
  No
  - Go To 4.
CHECK IF TIPM CAN BUS DTCS ARE PRESENT
1. With the scan tool, read TIPM DTCs.
  Are there any TIPM CAN BUS DTCs present?
  
  Yes
  - Refer to DIAGNOSIS AND TESTING and perform the appropriate diagnostic procedure.
  No
  - Go To 3.
TRANSMISSION DTCS PRESENT
1. Ignition on, engine not running.
2. With the scan tool, read DTCs in the TCM.
  Are there any DTCs present?
  
  Yes
  - Refer to DIAGNOSTIC CODE INDEX and perform the appropriate diagnostic procedure.
  No
  - Replace the Drive Train Control Module (DTCM) in accordance with the Service Information.
  - Refer to STANDARD PROCEDURE and perform the DTCM VERIFICATION TEST.
INTERMITTENT WIRING HARNESS AND CONNECTORS
1. The conditions necessary to set this DTC are not present at this time.
2. Using the wiring diagram/schematic as a guide, inspect the wiring harness and connectors.
3. Wiggle test the wiring harness and connectors while monitoring the scan tool data relative to this circuit.
4. Look for the data to change or for the DTC to reset during the wiggle test.
5. While monitoring the scan tool data relative to this circuit, move the selector switch to each position several times (if equipped).
  Were there any problems found?
  
  Yes
  - Repair as necessary.
  - Refer to STANDARD PROCEDURE and perform the DTCM VERIFICATION TEST.
  No
  - Test complete.