Diagnostic Test
WARNING: This page is about a different car, the 2012 RAM Pickup. However, it is still accessible from the selected car via links, so may be relevant.
- VERIFY DTC IS ACTIVE
- Turn the ignition on.
- With the scan tool, read and record ABS DTC's.
- With the scan tool, read and record Environmental Data (EV Data).
- With the scan tool, erase ABS DTC's.
- Cycle the ignition switch.WARNING:
To avoid possible serious or fatal injury, check brake capability is available before road testing.
- Test drive the vehicle by turning the vehicle left or right in a curving manner at a velocity between 10 and 20 km/hr (6 and 12 m.p.h.).
- Park the vehicle.
- With the scan tool, read ABS DTC's.
Does this DTC reset?
Yes
- Go To 2.
No
- Perform the ABS-INTERMITTENT CONDITION diagnostic procedure. Refer to ABS INTERMITTENT CONDITION .
- CHECK THE DYNAMICS SENSOR INSTALLATION NOTE:
Dynamics Sensor installation and mounting bolt torque is crucial for proper operation.
- Turn the ignition off.
- Check the Dynamics Sensor for damaged, modified, and bent mounting brackets.
- Check the Dynamics Sensor mounting bolts for a loose or over tightened condition.
Were any problems found?
Yes
- Repair as necessary.
- Perform the ABS VERIFICATION TEST. Refer to ABS VERIFICATION TEST .
No
- Replace the Dynamics Sensor or Antilock Brake Module in accordance with the Service Information.
- Perform the ABS VERIFICATION TEST. Refer to ABS VERIFICATION TEST .
NOTE:Vehicles without a Dynamics Sensor replace Antilock Brake Module.