6.7L Diesel Engine
WARNING: This page is about a different car, the 2011 RAM Pickup and 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - ISOLATOR |
| 2 - TAILPIPE |
| 3 - CLAMP |
| 4 - MUFFLER |
- Install the tailpipe into the muffler.
- Install the tailpipe hanger rods into the isolators
- Install the exhaust clamp, align the exhaust system, and tighten the clamp 48 N.m (35 ft. lbs.) torque.
- Check the exhaust system for contact with the body panels. A minimum of 25 mm (1.0 in.) is required between the exhaust system components and body/frame parts. Make the necessary adjustments, if needed.
- Lower the vehicle.
- Connect the battery negative cables.
- Start the engine and inspect for exhaust leaks. Repair exhaust leaks as necessary.