3.7L/4.7L/5.7L Engine

WARNING: This page is about a different car, the 2011 RAM Pickup and 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Tailpipe

Courtesy of CHRYSLER LLC

1 - INSULATOR

2 - TAILPIPE

3 - CLAMP

4 - MUFFLER

5 - CLAMP

6 - INSULATOR

7 - INSULATOR

8 - INSULATOR

Loosely assemble exhaust tailpipe (2) and clamp (2) to permit proper alignment of all parts.
Position the exhaust tailpipe (2) for proper clearance with the underbody parts.
Tighten all clamp nuts to 54 N.m (40 ft. lbs.) torque.
Hang the tailpipe (2) onto the isolator (1).
Check the exhaust system for contact with the body panels. A minimum of 25 mm (1.0 in.) is required between the exhaust system components and body/frame parts. Make the necessary adjustments, if needed.
Lower the vehicle.
Start the engine and inspect for exhaust leaks. Repair exhaust leaks as necessary. Refer to Diagnosis and Testing .