6.7L Diesel
WARNING: This page is about a different car, the 2011 RAM Pickup and 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - DOC/DPF |
| 2 - NUTS |
| 3 - EXHAUST PIPE - |
| 4 - EXHAUST PIPE SUPPORT |
| 5 - TURBOCHARGER CLAMP |
- Raise and support the vehicle on a hoist.
- Saturate the bolts and nuts with heat valve lubricant. Allow 5 minutes for penetration.
- Remove the exhaust pipe-to-DOC/DPF flange nuts (2).
- 4X4 Vehicles - Remove transfer case skid plate. Refer to PLATE, Skid, Front , Removal and PLATE, Skid, Transfer Case , Removal .
- 4X4 Vehicles - Remove transmission crossmember. Refer to CROSSMEMBER, Lower Control Arm , Removal and CROSSMEMBER, Transmission , Removal .
- Remove the exhaust pipe-to-turbocharger clamp (5) and discard.
- Remove the transmission mounted exhaust pipe support (4).
- Separate the exhaust pipe (3).
- Remove exhaust pipe (3).