Diagnostic Test
- VERIFY ACTIVE ORC DTC NOTE:
Ensure the battery is fully charged.
- Turn the ignition on.
- Wait 12 seconds, with the scan tool, read all ORC DTCs.
Does the scan tool display active B223B-00-VEHICLE CONFIGURATION MISMATCH - DTC?
Yes
- Go To 2.
No
- Refer to STANDARD PROCEDURE and perform the RESTRAINTS SYSTEM INTERMITTENT TEST.
- VERIFY ORC PART NUMBER
- With the scan tool, read the ORC part number.
Is the part number correct for the vehicle?
Yes
- Go To 3.
No
- Replace the ORC in accordance with Service Information.
- Refer to STANDARD PROCEDURE and perform the RESTRAINTS SYSTEM VERIFICATION TEST.
WARNING:Turn the ignition off, disconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.
WARNING:If the Occupant Restraint Controller (ORC) is dropped at any time, it must be replaced. Failure to follow these instructions may result in possible serious or fatal injury.
- With the scan tool, read the ORC part number.
- CHECK THE TIPM CONFIGURATION
- With the scan tool, check for Side Airbags and PAD Switch configuration.
Does the Vehicle Configuration in the TIPM match the Vehicle Configuration in the ORC?
Yes
- Replace the ORC in accordance with Service Information.
- Refer to STANDARD PROCEDURE and perform the RESTRAINTS SYSTEM VERIFICATION TEST.
WARNING:Turn the ignition off, disconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.
WARNING:If the Occupant Restraint Controller (ORC) is dropped at any time, it must be replaced. Failure to follow these instructions may result in possible serious or fatal injury.
No
- With the scan tool enter program network configuration and program the TIPM to the vehicle configuration.
- Refer to STANDARD PROCEDURE and perform the BODY VERIFICATION TEST.
- With the scan tool, check for Side Airbags and PAD Switch configuration.