LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 178 ((Occupant Restraint Controller (Orc) - Electrical Diagnostics)) >> DTC Troubleshooting >> B1BA5-00-Airbag Squib Configuration Mismatch - >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2012 RAM Pickup and 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. VERIFY ACTIVE DTC 
    NOTE:

    Ensure the battery is fully charged.

    1. Turn the ignition on.
    2. With the scan tool, read ORC DTCs.

      Does the scan tool display active B1BA5-00-AIRBAG SQUIB CONFIGURATION MISMATCH - DTC?

      Yes 

      • Go To  2.

      No 

  2. VERIFY ORC PART NUMBER 
    1. With the scan tool, read the ORC part number.

      Is the part number correct for the vehicle?

      Yes 

      • Go To  3.

      No 

        WARNING:

        Turn the ignition off, disconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.

      • WARNING:

        If the Occupant Restraint Controller (ORC) is dropped at any time, it must be replaced. Failure to follow these instructions may result in possible serious or fatal injury.

      • Replace the ORC in accordance with Service Information.
      • Refer to STANDARD PROCEDURE  and perform the RESTRAINTS SYSTEM VERIFICATION TEST.
  3. CHECK THE VIN WITH THE SCAN TOOL 
    1. With the scan tool, read the VIN.
    2. Compare the vehicle VIN to the ORC VIN.

      Is the correct VIN displayed?

      Yes 

      • Go To  4.

      No 

      • Replace the PCM in accordance with Service Information.
      • Refer to STANDARD PROCEDURE for 3.7L/4.7L/5.7L or STANDARD PROCEDURE for 6.7L and perform the POWERTRAIN VERIFICATION TEST.
  4. VERIFY TIPM CONFIGURATION 
    1. With the scan tool, read the TIPM configuration.

      Does the TIPM configuration match the vehicle equipment?

      Yes 

        WARNING:

        Turn the ignition off, disconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.

      • WARNING:

        If the Occupant Restraint Controller (ORC) is dropped at any time, it must be replaced. Failure to follow these instructions may result in possible serious or fatal injury.

      • Replace the ORC in accordance with Service Information.
      • Refer to STANDARD PROCEDURE  and perform the RESTRAINTS SYSTEM VERIFICATION TEST.

      No 

      • Re-configure or replace the TIPM in accordance with Service Information.
      • Refer to STANDARD PROCEDURE and perform the BODY VERIFICATION TEST.
scientia non olet · About LEMON Manuals