Diagnostic Test

WARNING: This page is about a different car, the 2012 RAM Pickup and 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

VERIFY ACTIVE DTC
NOTE:
Make sure the battery is fully charged.
1. Turn the ignition on.
2. With the scan tool, read ORC DTCs.
  Does the scan tool display active B007E-12-DRIVER SEATBELT RETRACTOR PRETENSIONER DEPLOYMENT CONTROL - CIRCUIT SHORT TO BATTERY DTC?
  
  Yes
  - Go To 2.
  No
  - Refer to STANDARD PROCEDURE and perform the RESTRAINTS SYSTEM INTERMITTENT TEST.
CHECK DRIVER SEAT BELT RETRACTOR TENSIONER FOR A SHORT TO BATTERY

Fig 1: Checking Driver Seat Belt Retractor Tensioner Circuit
Courtesy of CHRYSLER GROUP, LLC

WARNING:
Turn the ignition off, disconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.
1. Disconnect the Driver Seat Belt Retractor Tensioner harness connector.
  NOTE:
  Check connectors - Clean and repair as necessary.
2. Connect the (special tool #8443A, SRS Load Tool) and the (special tool #8443-8, Jumper, SRS Load) to the Driver Seat Belt Retractor Tensioner harness connector.
  WARNING:
  Turn the ignition on, then reconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.
3. With the scan tool, read the ORC DTCs.
  Does the scan tool display active B007E-12-DRIVER SEATBELT RETRACTOR PRETENSIONER DEPLOYMENT CONTROL - CIRCUIT SHORT TO BATTERY DTC?
  
  Yes
  - Go To 3.
  No
  - Replace the Driver Seat Belt Retractor Tensioner in accordance with the Service Information. Refer to RETRACTOR, SEAT BELT, REMOVAL .
  - Refer to STANDARD PROCEDURE and perform the RESTRAINTS SYSTEM VERIFICATION TEST.
CHECK (R503, R505) DRIVER SEAT BELT RETRACTOR TENSIONER CIRCUITS FOR A SHORT TO BATTERY
WARNING:
Turn the ignition off, disconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.
1. Disconnect the (special tool #8443A, SRS Load Tool) and the Jumper from the Driver Seat Belt Retractor Tensioner harness connector.
2. Disconnect the ORC harness connectors. Refer to CONTROLLER, OCCUPANT RESTRAINT, REMOVAL .
  NOTE:
  Check connectors - Clean and repair as necessary.
3. Connect the (special tool #8443-24, 32-Way Adapter) Adaptor to the ORC C1 harness connector.
  WARNING:
  Turn the ignition on, then reconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.
4. Measure the voltage of the (R505) Driver Seat Belt Retractor Tensioner Line 1 circuit between the (special tool #8443-24, 32-Way Adapter) connector C1 cavity 1 and ground.
5. Measure the voltage of the (R503) Driver Seat Belt Retractor Tensioner Line 2 circuit between the (special tool #8443-24, 32-Way Adapter) connector C1 cavity 2 and ground.
  Is there any voltage present on either circuit?
  
  Yes
  - Repair the Driver Seat Belt Retractor Tensioner circuits with voltage present.
  - Refer to STANDARD PROCEDURE and perform the RESTRAINTS SYSTEM VERIFICATION TEST.
  No
  - Replace the ORC in accordance with the Service Information. Refer to CONTROLLER, OCCUPANT RESTRAINT, REMOVAL .
  - Refer to STANDARD PROCEDURE and perform the RESTRAINTS SYSTEM VERIFICATION TEST.