Throttle Body: Installation: 5.7L

WARNING: This page is about a different car, the 2012 RAM Pickup and 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Throttle Body O-Ring - 5.7L

Courtesy of CHRYSLER GROUP, LLC

1 - INTAKE MANIFOLD

2 - THROTTLE BODY O-RING

Clean and check condition of throttle body-to-intake manifold O-ring (2).
Clean mating surfaces of throttle body and intake manifold.
Install O-ring (2) between throttle body and intake manifold.
Install throttle body to intake manifold by positioning throttle body to manifold alignment pins.
Install all throttle body mounting bolts finger tight.

Fig 2: Throttle Body Tightening Sequence
Courtesy of CHRYSLER GROUP, LLC

CAUTION:
The throttle body mounting bolts MUST be tightened to specifications. Over tightening can cause damage to the throttle body or the intake manifold.
Obtain a torque wrench. Tighten mounting bolts (as shown in illustration) in a mandatory torque criss-cross pattern sequence to 5.6 N.m (50 in. lbs.).

Fig 3: Throttle Body - 5.7L
Courtesy of CHRYSLER GROUP, LLC
Install electrical connector (2).
Install air plenum to flange (3).
Connect negative battery cable.
Using the diagnostic scan tool, erase all previous DTC's and perform the ETC Relearn function.