Alternative Procedure

WARNING: This page is about a different car, the 2012 RAM Pickup and 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Battery

Courtesy of CHRYSLER GROUP, LLC

NOTE:

If the electric fuel pump is not operating, the fuel tank must be removed and drained through the fuel pump module opening of the fuel tank.

Perform the Fuel System Pressure Release procedure. Refer to FUEL SYSTEM PRESSURE RELEASE . .
Disconnect and isolate the negative battery cable (1).
Raise and support the vehicle.
Remove the fuel tank. Refer to TANK, FUEL, REMOVAL .

Fig 2: Fuel Pump Module
Courtesy of CHRYSLER GROUP, LLC
Remove the fuel pump module (1). Refer to MODULE, FUEL PUMP, REMOVAL .
Position a 3/8" hose into the fuel pump module opening of the fuel tank.
Attach the opposite end of this hose to the Fuel Chief Gas Caddy 320-FC-P30-A or an OSHA approved gas caddy.
Using the gas caddy, evacuate the fuel tank.