HOMELINK® Transceiver
Each of the HomeLink® transceiver push buttons controls an independent radio transmitter channel. Each of these three channels can be trained to transmit a different radio frequency signal for the remote operation of garage door openers, motorized gate openers, home or office lighting, security systems or just about any other device that can be equipped with a radio receiver in the 286 to 399 Megahertz (MHz) frequency range for remote operation. The HomeLink® transceiver is capable of operating systems using either rolling code or non-rolling code technology. For information on programing. Refer to STANDARD PROCEDURE .
The HomeLink® transceiver cannot be repaired, and is only available for service as part of the EOM. This unit includes the electronics and push button switches for the HomeLink® transceiver, the electronics for the Remote Compass Module (RCM) and the plastic module case. For service information, and. Refer to MODULE, COMPASS, REMOVAL . Refer to MODULE, COMPASS, INSTALLATION .