LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1669 (Front Axle - 235 Aa (9 1/4) - 2500 Hd) >> Seal, Axle Drive Shaft >> Removal >> Left >> Notes

Seal, Axle Drive Shaft: Removal: Left: Notes

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

If replacing the left axle seal the right axle seal must be replaced as well.

  1. Remove hub bearings and axle shafts.
    GC0155100Courtesy of CHRYSLER GROUP, LLC
  2. Remove the 4WD shift actuator (1).
    GC0155386Courtesy of CHRYSLER GROUP, LLC
  3. Remove the 4WD shift collar (2).
  4. Remove the right axle shaft seal. Refer to SEAL, AXLE DRIVE SHAFT, REMOVAL .
    GC0155391Courtesy of CHRYSLER GROUP, LLC
  5. Slide the intermediate shaft (1) out the right axle tube.
    NOTE:

    Hold the ball bearing (2) in place while removing the intermediate shaft.

  6. Remove differential from differential housing.
  7. Remove differential bearing adjusters.
    GC0107644Courtesy of CHRYSLER GROUP, LLC
  8. Remove axle seal (2) located behind adjusters with Receiver (special tool #8498, Receiver, Axle Shaft Seal) and Extractor (special tool #6310, Remover, Bearing/Seal).
    GC0107645Courtesy of CHRYSLER GROUP, LLC
  9. Install Receiver (special tool #8498, Receiver, Axle Shaft Seal) (1) into the adjuster bore.
  10. Install Extractor Rod (special tool #6310, Remover, Bearing/Seal) with Extractor Foot (special tool #6310-9, Head) (2) through the receiver and axle seal.
    GC0107646Courtesy of CHRYSLER GROUP, LLC
  11. Install Extractor Plate (special tool #6310-2, Disc) and Nut (special tool #6310-7, Nut) (2) on the extractor rod (1).
  12. Tighten nut (2) on extractor rod (1) to pull seal into the receiver.
scientia non olet · About LEMON Manuals