LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1669 (Front Axle - 235 Aa (9 1/4) - 2500 Hd) >> Removal

Section 1669 (Front Axle - 235 Aa (9 1/4) - 2500 Hd): Removal

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
  1. With vehicle in neutral, position vehicle on hoist.
  2. Remove brake calipers and rotors.
  3. Disconnect ABS wheel speed sensors.
    GC0155439Courtesy of CHRYSLER GROUP, LLC
  4. Remove the brake line bracket bolt (1) from the control arm brackets.
    GC0155421Courtesy of CHRYSLER GROUP, LLC
  5. Remove the brake line bolt (1) from the coil spring lower bracket.
  6. Disconnect axle vent hose.
  7. Remove front propeller shaft.
    GC0155232Courtesy of CHRYSLER GROUP, LLC
  8. Disconnect the 4WD actuator (2) connector.
  9. Remove stabilizer bar links at the axle brackets.
  10. Remove track bar bolt from the axle. Refer to TRACK BAR, FRONT, REMOVAL .
    GC0155457Courtesy of CHRYSLER GROUP, LLC
  11. Disconnect the left tie rod end (1) from the steering knuckle.
    GC0155474Courtesy of CHRYSLER GROUP, LLC
  12. Disconnect the right tie rod (1) from the steering knuckle.
  13. Disconnect the drag link (2) from the right steering knuckle.
  14. Disconnect the steering damper from the axle bracket (3).
    NOTE:

    Secure steering components that are not removed.

  15. Position lift under the axle assembly and secure axle to lift.
  16. Mark suspension alignment cams for installation reference.
    GC0155456Courtesy of CHRYSLER GROUP, LLC
  17. Remove lower shock absorbers bolts (1) from axle brackets.
  18. Remove the upper and lower bolts (2 and 3) from the left and right control arms.
  19. Lower the axle. The coil springs will drop with the axle.
  20. Remove coil springs from the axle bracket.
scientia non olet · About LEMON Manuals