Sensor, Speed, Output: Removal
WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - OUTPUT SPEED SENSOR |
| 2 - LINE PRESSURE SENSOR |
| 3 - INPUT SPEED SENSOR |
- Raise vehicle.
- Place a suitable fluid catch pan under the transmission.
- Remove the wiring connector from the output speed sensor (1).
- Remove the bolt holding the output speed sensor (1) to the transmission case.
- Remove the output speed sensor (1) from the transmission case.