GEARTRAIN, Planetary: Disassembly

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

The 66RFE transmission does not use a number 7 thrust bearing.

Courtesy of CHRYSLER GROUP, LLC

1 - THRUST BEARING NO. 1

2 - THRUST BEARING NO. 2

3 - THRUST BEARING NO. 3

4 - THRUST BEARING NO. 4

5 - THRUST BEARING NO. 5

6 - THRUST BEARING NO. 6

8 - THRUST BEARING NO. 8

9 - THRUST BEARING NO. 9

10 - THRUST BEARING NO. 10

11 - THRUST BEARING NO. 11

12 - THRUST BEARING NO. 12

13 - OUTPUT SHAFT BEARING

NOTE:

The number 11 thrust bearing is captured under the input planetary carrier pinion gears and is not serviceable.

Courtesy of CHRYSLER GROUP, LLC

Remove the snap-ring (1) holding the input annulus (8) onto the input carrier (7).
Remove the input annulus (8) from the input carrier (7).
Remove the number 9 thrust bearing from the reverse planetary carrier (3).
Remove the reverse planetary gear carrier (3).
Remove the number 10 thrust bearing (4) from the input sun gear (5).
Remove the input sun gear (5) from the input carrier (7).