Assembly, Input Clutch: Description
WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - INPUT CLUTCH HUB |
| 2 - O-RING SEALS |
| 3 - SEAL |
| 4 - SNAP-RING |
| 5 - SNAP-RING |
| 6 - UD BALANCE PISTON |
| 7 - SNAP-RING |
| 8 - UD PISTON |
| 9 - UD SPRING PACK |
| 10 - UD INNER DISC |
| 11 - UD CLUTCH |
| 12 - UD OUTER DISC |
| 13 - INPUT CLUTCH RETAINER |
| 14 - SEAL |
| 15 - OD/REV PISTON |
| 16 - BELLEVILLE SPRING |
| 17 - SNAP-RING |
| 18 - SEAL RINGS |
| 19 - INPUT SHAFT |
| 20 - LUBRICATION CHECK VALVE AND SNAP-RING |
| 1 - THRUST BEARING NUMBER 3 |
| 2 - OD HUB/SHAFT |
| 3 - SNAP-RING (WAVE) |
| 4 - REV/OD PRESSURE PLATE |
| 5 - THRUST BEARING NUMBER 4 |
| 6 - SNAP-RING (FLAT) |
| 7 - REVERSE HUB/SHAFT |
| 8 - REVERSE CLUTCH |
| 9 - REVERSE REACTION PLATE |
| 10 - SNAP-RING (SELECT) |
| 11 - OD OUTER DISC |
| 12 - OD INNER DISC |
| 13 - OD CLUTCH |
| 14 - SNAP-RING (TAPERED) |
| 15 - UD/OD REACTION PLATE |
| 16 - SNAP-RING (FLAT) |
| 17 - UD HUB/SHAFT |
| 18 - THRUST BEARING NUMBER 2 |
Three hydraulically applied input clutches are used to drive planetary components. The underdrive, overdrive, and reverse clutches are considered input clutches and are contained within the input clutch assembly.
The input clutch assembly also contains:
- Input shaft
- Input hub
- Clutch retainer
- Underdrive piston
- Overdrive/reverse piston
- Overdrive hub
- Underdrive hub