LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 166 (Power Seats (Service Information)) >> Standard Procedure >> Standard Procedure - Memory System Programming >> To Disable A RKE Transmitter Linked To Memory

To Disable A RKE Transmitter Linked To Memory

WARNING: This page is about a different car, the 2012 RAM Pickup and 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition switch to the OFF position and remove the key.
  2. Press and release the memory SET button located on the driver's seat.
  3. Within 10 seconds, press and release the UNLOCK button on the RKE transmitter.

To disable another RKE transmitter linked to either memory position, repeat Steps 1-3 for each RKE transmitter.

NOTE:

The capability to link RKE transmitters to memory is enabled when delivered from the factory. The capability to link RKE transmitters to memory can be disabled (or later re-enabled) by an authorized dealer. For vehicles equipped with the electronics vehicle information center (EVIC) under setup features.

scientia non olet · About LEMON Manuals