Diagnostic Test

WARNING: This page is about a different car, the 2012 RAM Pickup and 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

TEST FOR INTERMITTENT CONDITION
NOTE:
Verify that the FOBIK in use is the FOBIK causing the DTC to set.
1. Turn the ignition on.
2. Using the scan tool, record and erase the DTCs.
3. Turn the ignition off and remove the FOBIK.
4. Operate the FOBIK transmitter in all positions several times.
5. Turn the ignition on.
6. Using the scan tool, read the active DTCs.
  Does the scan tool display: B1A13-RKE FOB 4 BATTERY LOW as active?
  
  Yes
  - Replace the FOBIK battery. Test the FOBIK using the RF Detector (special tool #9001, Rf Detector). If the Strength Display does not display "Strong", replace and program the FOBIK using the scan tool.
  - Refer to STANDARD PROCEDURE and perform the BODY VERIFICATION TEST.
  No
  - Test complete. The conditions that caused this code to set are not present at this time.
  - Refer to STANDARD PROCEDURE and perform the BODY VERIFICATION TEST.