Diagnostic Test
WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
RUN "SET RIDE HEIGHT LEVEL" ROUTINE VIA SCAN TOOL
- Turn the ignition on.
- With the scan tool, Run the "Set Ride Heigh Level" routine
- Turn the ignition off.
- Turn the ignition on.
- With the scan tool, read the DTCs in the ASCM.
Is the DTC Active?
Yes
- Drive the vehicle above 25 mph for at least 2 min
- Repeat Step
No
- Test Complete
- Perform the ASCM VERIFICATION TEST. Refer to STANDARD PROCEDURE - ASCM VERIFICATION TEST .