Diagnostic Test
WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
CHECK FOR AN ACTIVE DTC
- Turn the ignition on.
- With the scan tool, create a Vehicle Scan Report and attach it to the repair order.
- With the scan tool, read the Occupant Restraint Controller (ORC) DTCs.
Is the DTC active or stored?
Yes
WARNING:If the Occupant Restraint Controller (ORC) is dropped at any time, it must be replaced. Failure to take the proper precautions can result in accidental airbag deployment. Failure to follow these instructions may result in possible serious or fatal injury.
WARNING:Turn the ignition off disconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.
- When this DTC is set, the module self test has discovered an internal fault that cannot be repaired and the module must be replaced regardless of DTC status.
- Replace the ORC module according to the Service Information. Refer to MODULE, OCCUPANT RESTRAINT (ORC), REMOVAL .
- Perform the Occupant Restraint Controller VERIFICATION TEST. Refer to RESTRAINTS SYSTEM VERIFICATION TEST .
No
- Review the Vehicle Scan Report and Repair any other DTCs that have set with the appropriate procedure in Service Information.