Motor, Wiper: Removal
WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
- Unlatch and open the hood.
- Remove both wiper arms from the wiper pivots. Refer to ARM, WIPER, REMOVAL .
- Disconnect and isolate the negative cable from the battery.
- Remove the cowl plenum cover/grille panel from over the cowl plenum. Refer to COVER, COWL PANEL, REMOVAL .
- Disconnect the left headlamp and dash wire harness connector (4) from the wiper motor (6) pigtail wire connector.
- Remove the nut (5) that secures the crank arm (3) to the wiper motor output shaft.
- Remove the three screws (1) that secure the wiper motor to the center bracket of the wiper linkage module.
- Remove the wiper motor from under the wiper linkage module bracket and out of the cowl plenum.