LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1633 (Wiper System & Washer System - (Service Information) - 2500 Hd) >> Module, Light Rain Sensor >> Installation

Module, Light Rain Sensor: Installation

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
GC0154621Courtesy of CHRYSLER GROUP, LLC
CAUTION:

During installation be certain not to touch or contaminate the optical lenses of the Light Rain Sensor Module (LRSM) or the glass through which the LRSM optics are focused. Contaminated optics will negatively impact LRSM performance.

  1. Position the Light Rain Sensor Module (LRSM) (5) to the center of the mounting bracket (2) on the inside of the windshield (1) near the inside rear view mirror mounting button (3).
  2. Depress both sides of the spring steel retaining strap on the LRSM simultaneously until the hooks of the strap engage the tabs on each side of the mounting bracket on the windshield.
  3. Reconnect the wire harness connector (4) to the LRSM.
  4. Reinstall the inside rear view mirror mounting bracket trim cover. Refer to MIRROR, REARVIEW, INSTALLATION .
  5. Reconnect the negative cable to the battery.
scientia non olet · About LEMON Manuals