Lamp, Dome: Removal: Bulb

WARNING: This page is about a different car, the 2012 RAM Pickup and 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

There are two types of single lamp dome lamps available in this vehicle: one with a switch that is activated by depressing the lamp lens, and one without a switch. The bulb types and service procedures are identical for both of these lamps.

Fig 1: Dome Lamp Bulb (Rear)

Courtesy of CHRYSLER GROUP, LLC

Disconnect and isolate the battery negative cable.
Insert the tip of a small flat-bladed screwdriver into the notch on one side of the dome lamp between the lens (4) and the lamp housing (1).
Gently pry the notched edge of the lens downward until it unsnaps from the housing.
Swing the notched end of the lens downward far enough to access the bulb (3).
Carefully unsnap the bulb from the two bulb holders within the dome lamp housing.