Lamp, Bezel, Center: Removal: Bulb
WARNING: This page is about a different car, the 2012 RAM Pickup and 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor or instrument panel component diagnosis or service. Refer to WARNING . Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental airbag deployment.
- Disconnect and isolate the battery negative cable.
- Remove the center bezel lamp unit (4) from the instrument panel center bezel. Refer to LAMP, BEZEL, CENTER, REMOVAL .
- Depress the latch tab (2) and slide the hood (1) off of the end of the lamp housing.
- Pull the base of the bulb (3) straight out of the bulb holder within the lamp housing.