LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1621 (Propeller Shaft - 2500 Hd) >> U-Joint, Single CARDAN >> Disassembly >> With Injected Ring

With Injected Ring

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
GC0091597Courtesy of CHRYSLER GROUP, LLC
  1. Place shaft yoke in vise.
  2. Position U-joint press (1) with receiver (2) on propeller shaft yoke.
    GC0091598Courtesy of CHRYSLER GROUP, LLC
  3. Pressed U-joint bearing caps (1) out of shaft yoke (2).
  4. Remove lower bearing cap from shaft yoke.
    GC0091599Courtesy of CHRYSLER GROUP, LLC
  5. Turn shaft over and position press (1) with receiver (2) on shaft yoke.
  6. Press remaining U-joint bearing cap out of shaft yoke.
    GC0083222Courtesy of CHRYSLER GROUP, LLC
  7. Remove flange (1) with U-joint out of shaft yoke (2).
    GC0091600Courtesy of CHRYSLER GROUP, LLC
  8. Position U-joint press (2) with receiver (1) on flange.
    GC0091601Courtesy of CHRYSLER GROUP, LLC
  9. Press U-joint bearing caps (1) out of flange (2).
  10. Remove bearing cap on the outside of the flange.
    GC0091602Courtesy of CHRYSLER GROUP, LLC
  11. Position U-joint press (2) with receiver (1) on flange.
  12. Press remaining U-joint bearing cap out of flange.
  13. Remove U-joint from flange.
scientia non olet · About LEMON Manuals