Shaft, Drive, Rear Heavy Duty: Installation
WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Drive shaft bolts must be replaced or cleaned and Mopar® Lock and Seal Adhesive or equivalent applied.
- Align transmission flange (1) and propeller shaft reference marks. Install flange bolts (2) and tighten to the proper torque specifications. Refer to TECHNICAL SPECIFICATIONS .
- If two piece propeller shaft, align center bearing (1) with reference marks on center bearing bracket and tighten bolts to the proper torque specifications. Refer to TECHNICAL SPECIFICATIONS .NOTE:
Drive shaft bolts must be replaced or cleaned and Mopar® Lock and Seal Adhesive or equivalent applied.
- Align reference marks on propeller shaft and pinion flange. Install companion flange (1) bolts and tighten to the proper torque specifications. Refer to TECHNICAL SPECIFICATIONS .
CAUTION:
Failure to follow these instruction may result in a driveline vibration.