Shaft, Drive, Front Heavy Duty: Installation
WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
- Install propeller shaft (1) with all reference marks aligned.NOTE:
Drive shaft bolts must be replaced or cleaned and Mopar® Lock and Seal Adhesive or equivalent applied.
- Install transfer case companion flange (2) bolts and tighten to the proper torque specifications. Refer to TECHNICAL SPECIFICATIONS .NOTE:
Drive shaft bolts must be replaced or cleaned and Mopar® Lock and Seal Adhesive or equivalent applied.
- Install axle companion flange (3) bolts and tighten to the proper torque specifications. Refer to TECHNICAL SPECIFICATIONS .
- Install skid plate, if equipped.